Source-audio Hot Hand 3 Universal Wireless Adapter Manual de usuario descargar pdf (Pagina 10)

Selecting an output mode

The Hot Hand 3 Receiver can output a total of three control signals:

two on the Sensor Output and one on the Expression Output. By

default, the X-axis signal of the Hot Hand ring is processed and sent

to the Expression Output and the Sensor Output sends X and Y-axis

signals without any processing. There are six different output modes

available to select between the three axis outputs as well as a selec-

tion to enable or disable processing on the Sensor Output signals.

To enter the output selection mode, press and hold CALIBRATE while

powering on the receiver until the green MODE LED begins to blink.

Alternatively, when the unit is powered on normally you can press and

hold the CALIBRATE unit to perform a RESET and continue to hold the

button to get into the editing mode.

10 | Selecting an output mode

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Source-audio Hot Hand 3 Universal Wireless Adapter Manual de usuario Pagina 10